We produce
fiberglass parts.
Glass fiber set in resin, engineered and manufactured to your requirement, from a first idea or from your own mold.
Saraco is a fiberglass specialist. One material, glass fiber set in resin, understood deeply enough to become the enclosure, the tank, the panel or the part your project needs. We develop it with you, we make it, and we stand behind it.
Every project enters through one of two doors.
01
I have an idea or a requirement
You know what the part must do, not yet what it is. We work it out together, laminate, geometry and tooling where it is needed, then manufacture it.
- You bring the requirement
- We develop and prototype
- We produce and deliver
02
I have a design or a mold
You have drawings, a specification or existing tooling. We select the material for the service conditions, produce, inspect and deliver.
- You bring the design or mold
- We confirm material and method
- We produce and deliver
Step 1 of 5
Glass fiber.
E-glass drawn into filaments six to ten micrometres across, a tenth of a human hair, and laid into a sheet. The fiber carries the load.
Lighter than steel
60 to 80% lighter, by weight
Does not conduct
8 to 20 kV/mm dielectric strength
Does not rust
0.3 to 0.4 W/m·K, 1/100 the heat steel conducts
FRP capabilities. Some of what we produce with it.
Electrical enclosures
Non-conductive bodies that need no earthing, gasketed to IP66, UV-stable outdoors. Meter boxes, distribution and fuse boxes: the parts Saraco has made in series.
Manhole and grating covers
A fraction of the weight of cast iron, no scrap value so no theft, non-conductive, molded to the load class the site needs.
Sectional water tanks
Molded panels bolted on flanges. No corrosion, no lining, and sizes to tens of thousands of litres from the same panel.
Pipes
Light, corrosion-free lines for water, sewage and chemicals, flanged or jointed to length.
01Electrical enclosures
02Manhole and grating covers
03Sectional water tanks
04Pipes
+and more, by sectorInside the factory.
Raw material
Glass fiber, resin and additives are weighed and mixed to the formulation the part needs.
Molding
The charge goes into the mold and is formed under heat and pressure into the part.
Machining
Openings, holes and edges are cut on the CNC to the drawing.
Quality
Every part is inspected against the specification before it leaves.




Saraco Industries, Beirut
01Raw material
02Molding
03Machining
04Quality

